Auto-Tie Baler
Traditionally, the balers do not have the auto-tie feature and thus the early operations of the balers in farm still required the supervision of a farm worker. Before, when the machine, which used to be the round baler, bales the hays, the baled product goes out of the machine untied. Since the bales were round-shaped, the rolled bales roll on the ground reaching far areas the moment it goes out of the machine. The farm worker then has to tie manually the rolled bales in order to prevent the product from decompressing and scattering again. Sometimes, in the course of rolling from the machine, decompression happens and it becomes difficult to tie the bales.
With more advances in technology, the new types of bales today have the tying feature called the auto-tie baler. Olympic equipment has one of the most sophisticated kinds and selections of this baler that comes from Balemaster. This baler has the capacity to cope up with your baling needs ranging from ten bales to more than five hundred bales per day. Technological breakthrough also allowed the use of this baler system without need of close supervision as the machine has superior design and the diagnostic and troubleshooting control is on a touch screen display. Likewise, factory owners would be more than happy to purchase this machine since it has a high-energy efficiency and low maintenance needs. The machine has hydraulic power packs ranging from 25 to 225 horsepower.
Among the salient features of the auto-tie baler is that it has a wire tier that is automatic and heavy duty. The entire of the machine is weld in such a way as to meet heavy-duty requirement. Further, the wire tier can complete the tying process in less than ten seconds. Unlike the wire tiers available in the market, the machine's design is more simplistic allowing the tying process to be simpler. As mentioned, the machine requires less supervision because the operator need not even consult the user's manual for every troubleshooting problem since the machine has a touch screen controller that is comprehensive enough to show more than fifty information on the screen. There is also a modem feature that allows the data transmission from the machine to the Service Center of Olympics and the Balemaster.
Still another important feature of the Auto-tie baler is its dust control system which is an advanced dust control system having an air blaster accessory that allows automatic cleaning of the ram of the baler in order to lessen the maintenance cost. It also has bale density control system that uniquely regulates the tension on the baled material. Through this unique feature, the machine is able to squeeze the material at greater force in order to have the greatest possible density of the bale without need of further adjustments on the auto-tie baler.
Finally, the auto-tie baler has a Main Hydraulic Cylinder that is Trunnion Mounted on all its E Series models. The cylinders have a diameter of 6, 8, 10 and 12 that would definitely meet whatever your baling density requirement is.
